TL;DR — Key Takeaways
- Eight minutes from approval to chaos: An FAA official signed off on a fiber-optic network upgrade just eight minutes before a communications failure triggered a nationwide ground stop.
- The blame game gets complicated: Transportation Secretary Sean Duffy singled out L3Harris, but the FAA’s direct oversight raises questions about where responsibility really lies.
- Modernization meets mission-critical risk: With thousands of installations completed, the outage exposes the potentially enormous consequences of upgrading aging aviation infrastructure.
A Federal Aviation Administration (FAA) official supervised, tested, and signed off on telecommunications upgrade work in rural Arkansas just eight minutes before a radio network failure triggered a 4.5-hour nationwide ground stop on Friday.
The revelation, according to a Washington Post report, complicates public efforts by Transportation Secretary Sean Duffy to blame L3Harris Technologies, the defense contractor hired to modernize the FAA’s communications infrastructure.
Following the disruption, which impaired high-altitude radio communication between pilots and air traffic controllers, Duffy questioned whether “incompetence” by L3Harris was responsible, urged the company to “hire better minds,” and suggested bringing in competing contractors to finish the project.
However, a person familiar with the investigation, speaking on the condition of anonymity to discuss the ongoing inquiry, characterized Duffy’s remarks as “inflammatory” and “insulting,” noting that they overlook the agency’s direct oversight at the El Dorado, Ark., facility.
“We’re working really hard to get to a root cause,” the source told the Post, adding that “everyone is jumping to conclusions.”
The upgrade in Arkansas was part of an urgent, nationwide FAA initiative to replace aging copper wires with modern fiber-optic cables before telecommunications carriers decommission the old lines entirely.
L3Harris is the primary contractor for the modernization push, which is roughly 70% complete after more than 4,600 equipment installations.
According to the source, the Arkansas project began in October and followed standard protocols, including step-by-step plans and contingency workarounds approved by the FAA. Because the remote site handled minimal traffic, the agency conducted an operational risk assessment and cleared the final cutover to proceed ahead of a busy travel weekend.
On Friday afternoon, an L3Harris technician switched the system from the old copper network to the new fiber-optic hardware while an FAA official observed. The official tested the new equipment and formally approved the job, with everything appearing to function normally. Eight minutes later, air traffic control centers across the country began losing radio stability, prompting the rare national ground stop.
Duffy has stated that the newly installed router in Arkansas malfunctioned, flooding the network with more than 1,000 connection attempts every few seconds and overwhelming the system.
Investigators from the FAA and L3Harris are currently examining the device at a laboratory in Florida.
While L3Harris continues its broader modernization work using alternative hardware, it has temporarily halted installations of the specific Juniper circuit-to-packet routers implicated in the outage, 68 of which are already in service.
Adam Bauer, a spokesman for Juniper manufacturer HPE, maintained that based on available information, the company’s equipment “was working as configured.”
When asked for comment, the FAA referred reporters to a Tuesday news conference on Capitol Hill where Duffy and FAA Administrator Bryan Bedford discussed the agency’s response and potential contract changes.

